Ultrasonic welding and/or cutting machines
Belsonic SeamStar BS 004
Continuous ultrasonic sewing machine for Line Bonding of stitched fabrics
Features.
The BelSonic BS 4010 ultrasonic sewing machine is widely used in the seamless garment industry where ultrasonic welding between two panels is required, such as “Line Bonding” application.
Belsonic SeamStar 3010
The SeamStar 3010 is the ideal 30 kHz machine for simultaneous cutting & sealing jobs.
Since the puller of the machine is located to the immediate right of the pattern wheel the fabric will be pulled as from the point of engagement.
The usable width of the pattern wheel on this machine is limited to 10mm.
Download Factsheet: Belsonic SeamStar 3010
Belsonic SeamStar BS 2010
The SeamStar 2010 is the ideal machine for simultaneous cutting & sealing jobs.
Since the puller of the machine is located to the immediate right of the pattern wheel the fabric will be pulled as from the point of engagement.
The usable width of the pattern wheel on this machine is limited to 10mm.
It can be equipped with a horn of 25 or 50mm diameter.
Belsonic SeamStar BS 2060
The SeamStar 2060 features a larger and higher wheel allowing for increased operator access to the machine.
The SeamStar will sew, seal and trim in one pass at speeds up to 4 times faster than traditional sewing machines. The need for thread, glue or other consumables is eliminated, and there is very little training required to operate the SeamStar machine
The usable width of the pattern wheel is max 22mm.
The machine can be equipped with a horn of 25 or 50mm diameter
Belsonic SeamStar BS 2060 Z
The SeamStar 2060 Z is equipped with an additional PLC control system that will :
- allow the pattern wheel to return to its original starting point when being lifted up
- will allow to work in distance mode where the machine will only perform a preset mm distance
The usable width of the pattern wheel is max 22mm.
The machine can be equipped with a horn of 25 or 50mm diameter
Belsonic SeamStar BS 150
The SeamStar BS 150 has a fixed horn on top of the machine and a pattern wheel inserted into the top surface of the working table.
This will allow for easier access during precise hand guided operations.
The BS 150 is equipped with an additional PLC control system that will :
- allow the pattern wheel to return to its original starting point when being lifted up
- will allow to work in distance mode where the machine will only perform a preset mm distance
Belsonic Seamstar ATA and OTA
The ATA or off the arm machine is equipped with a stationery horn and a canon arm including a pattern wheel that will allow for circular welding.
Tha OTA or around the arm machine is equipped with a stationery horn and an L shaped arm including a pattern wheel that will allow for tube welding.
Both pattern wheel width’s are limited to 10mm.